Outdoor air conditioning condenser unit

AC Crankcase Heater Not Working? Protect the Compressor Before Startup

Some air conditioners and heat pumps use a crankcase heater to warm the compressor during off cycles. This helps reduce refrigerant migration into compressor oil. It is an equipment-specific accessory, so a cool compressor shell or lack of visible warmth is not enough to diagnose a failure. The unit’s wiring diagram and service instructions determine when the heater should be energized.

What an owner can do

Before a long-idle system is restarted, check the owner’s manual for any required preheating time. Note recent contactor or compressor work and report unusual startup noises or repeated compressor trips. Do not feel, open, or test an energized outdoor unit, and do not energize a unit if its manual specifies a warm-up period that has not elapsed.

Technician checks

A qualified technician confirms the system is designed for a crankcase heater and checks whether the heater receives power during the correct part of the cycle. They inspect wiring and contactor configuration, measure the heater’s resistance with power isolated, and compare readings with the manufacturer’s data. A heater can be intact while its control wiring is wrong; replacing the part alone would not correct that fault.

Crankcase heaters and contactors involve line voltage. Avoid touching terminals or moving wires; electrical testing and repair belong to a trained technician.

Sources and video

HVAC School’s training covers crankcase heater operation and wiring. By Bryan Orr / HVAC School on YouTube:

Watch the original video. Further reading: HVAC School field guide to crankcase heaters and Copeland compressor application information.

Image credit: Vladislav Nikonov, “White air condenser unit”, under the Unsplash License. Article by HVAC Parts Center.

Regresar al blog