Furnace Starts, Then Shuts Off? How a Flame Sensor Fits In
Share
When a gas furnace lights and then shuts its burners off after a few seconds, a flame-sensor problem is one possible cause. The sensor confirms that flame is present; if the control does not receive the expected signal, it closes the gas valve as a safety response. A similar shutdown can also come from grounding, wiring, burner, ignition, or control faults, so replacing the sensor by guesswork may not solve it.
What you can safely do: record the thermostat message or furnace LED code, check that the filter is not blocked, and make sure supply and return grilles are open. If you smell gas, leave the home and call the gas utility or emergency service from outside. Do not repeatedly reset a furnace that locks out.
What requires a qualified technician: opening the burner compartment, cleaning or replacing the flame rod, checking flame current, testing grounds, and evaluating ignition or gas components. Carrier identifies a malfunctioning flame sensor as a professional repair issue. The exact service manual matters because sensor position and signal requirements differ by model.
Use the furnace’s own fault-code chart and model-specific parts list; a universal replacement must match the approved application and be positioned to the manufacturer’s specification.
Sources
- Carrier: Furnace flame sensor symptoms and repair
- HVAC School: Flame Sensor Troubleshooting & Install
Repair video
HVAC School; instruction by Bert Testerman on YouTube: Flame Sensor Troubleshooting & Install.
Image
Image credit: Stephan HK, “White AC condenser units”, used under the Unsplash License. Article by HVAC Parts Center.